9
B
ACK
R
AIL
A
SSEMBLY
1. Remove the Upright Tubes, Horizontal Tubes and
Step Assemblies from the carton.
2. Using the 7/32” hex key wrench, remove the
three silver Screws from inside surface of
the first Back Rail Plate and set them aside.
Do not remove the black Screw.
3. Remove the two inner Nylon Spacers and
set them aside.
Do not remove the two outer Nylon Spacers.
4. Rotate the Back Rail Plate forward.
5. Lift the Link Bar and slide it onto the non-bronze Sleeve.
With the End Cap side facing down, slide the two slots
of one Upright Tube onto the two pins fitted with the
bronze Sleeves until it contacts the Nylon Spacers.
Note: The bronze Sleeves and Nylon Spacers
are loose. If they fall off or move out
of place, return them to their original
position.
6. Replace the two inner Nylon Spacers
that were removed in Step #3.
Link Bar Over
Non-Bronze
Sleeve
End
Cap
Upright
Tube
A
SSEMBLY
CONTINUED
Rotate Back
Rail Plate
Silver
Screws
Bronze
Sleeves
Inner Nylon
Spacers
Silver
Screw
Outer Nylon
Spacers
Replace
Inner
Nylon
Spacers
