9
TO reverse The sTep ArrANgemeNT
(3-
sTep rIser wITh OpTIONAl
4
Th
-
sTep AddITION
)
NOTE: Steps cannot be reversed on a 2-Step Riser.
1. Take off the first and fourth steps by loosening the capscrews that hold the steps to the legs.
Don’t loosen the second or third steps capscrews yet.
2. Turn the first and fourth steps end-for-end, and switch their places as shown.
Reattach the steps to the legs.
3. Remove the second and third steps.
Turn them end-for-end, switch their places as shown, and reattach them to the legs.
4. Be sure all capscrews are tightened securely.
5. Remove the unit-to-unit clamps, and reattach them at the opposite end of the steps.
6. If a back rail is used on a reversed riser, reverse the rail loop also.
To do this, depress the two snaps, separate the loop, turn the rail around, and snap it back together
(see page 11).
