4
T
UBA
R
EST
A
SSEMBLY
1.
Place the Nota Chair upside down on a table, bench, or floor surface
covered with a pad or blanket to protect the seat and back surfaces.
2.
Pre-cut the Adapter Bracket mounting hole threads in the
pre-punched holes of the chair frame using the
5
/
16
x
3
/
4
” Self-Tapping Screws (3).
This is easiest done with an Electric Drill
fitted with a
1
/
2
" Socket, but can also be done
with a Socket Wrench, although more difficult.
It is easier to obtain straight threads with
an Electric Drill, which makes the mounting
of the Base Assembly easier.
After cutting the threads, remove the
Self-Tapping Screws.
3.
Orientate the four threaded holes of the
Adapter Bracket (4) towards the outside
of the chair as marked on the Bracket.
Attach both Adapter Brackets (4) to the
underside of the chair. Use the two
5
/
16
x
3
/
4
”
Self-Tapping Screws (3) in each Bracket.
Make sure the four threaded holes of the
Adapter Bracket (4) are oriented towards the
outside of the chair as marked on the adapter.
4.
Press the Snap Button and remove the
Rest Assembly from the Base Assembly.
Attach the Base Assembly (1) to the Adapter
Brackets using the middle and rear holes of the Base Assembly,
and the first (front) and third threaded holes of each Bracket.
a.
Use four
5
/
16
-18 x 1
1
/
4
” Cap Screws (8)
and four
5
/
16
Washers (9).
Note:
Make sure that the Cap Screws
are hand started into the threaded
holes of the Adapter Bracket before
tightening with a wrench.
The Base Assembly may have to be
moved around slightly to start all four
of the Cap Screws in the threaded holes.
b.
Tighten the Cap Screws with a
wrench but do not exceed a tightening
torque of 14 ft-lbs (170 in-lbs).
Over tightening the screws may
damage the threads in the Brackets.
The use of an In-Lb Torque Wrench
is highly recommended to prevent
over-tightening of the screws.
5.
Place the chair upright. Press the Snap Button
and slide the Rest Assembly (2) into the base.
Top Plate of Rest Assembly can face forward
(as shown) or backward.
To adjust height of Rest Assembly, position
the Snap Button in the appropriate hole.
Adapter
Bracket
Self-Tapping
Screw
Adapter
Bracket
Base
Assembly
Cap-Screw
Washer
Rest
Assembly
Snap
Button
Washer
Cap-Screw
Washer
Washer
Bottom View of
Adapter Bracket
