P.20
(Fig 3.2)
3.2 Click Camera 1 to process searching. As below fig (Fig 3.2)
3.3 While the Camera is under the standby mode, press Lamp/Setup and last 4
seconds, Lamp/Setup will then continuously flash in blue. Meanwhile, click the
pairing button on the PC screen to process pairing. After Camera was
successfully paired with USB Receiver, Lamp/Setup will keep in blue, and
images from that camera display simultaneously on the pc screen. Once failed to
pair with USB Receiver, Lamp/Setup flashes once 2 seconds. User may follow
the above steps to make pairs again. As above fig (Fig 3.3)
Wireless
Digital
Camera
WS-CAMERA
2.4G
Wireless
Digital
Camera
WS-CAMERA
2.4G
(Fig 3.3)
It flashes with blue after pairing
has succeeded.
3.4 If search failed, users will be informed by the notification “Match complete, no
camera detected” . As below fig (Fig 3.4)
3.5 Once pairing has succeeded, “Match complete, a camera had been connected”
shows up. As above fig (Fig 3.5)
(Fig 3.4)
(Fig 3.5)
Match complete, no camera detected.
Camera1
Match complete, a camera had been connected.
Pairing/Operation Method of Wireless Digital CCDL Camera and Wireless Digital
USBH Receiver
Pairing/Operation Method of Wireless Digital CCDL Camera and Wireless Digital
USBH Receiver
Lamp
WENSHING
Confidential
Do
Not
Distribution
