WERKU WK501000, Original Instructions Manual

English

ENG 

ORIGINAL INSTRUCTIONS

3

in moving parts.

If there are devices for connecting 

means for extracting and collecting dust, make sure 

they are connected and properly used.

The use of 

these devices can reduce dust related hazards.

CONNECTIONS AND AIR TYPE.

Quick connections should be used for connections 

with the compressed air system and male non-wa-

tertight sleeve must be installed in the paint spray 

gun so that no air is compressed after the discon-

nection.

Never use oxygen, combustible gases or 

any other bottled gases.

Never use oxygen tanks, 

fuel gas, etc. as a power source for the paint spray 

gun.

Use of these gases or other bottled gases is 

dangerous, because the paint spray gun could ex-

plode.

Use only clean, dry and regulated compres-

sed air.

MAXIMUM PRESSURE.

The paint spray gun should be connected to a sou-

rce of compressed air if the pressure does not ex-

ceeded more than 10% the maximum allowable 

pressure of the paint spray gun; in case of higher 

pressures a pressure reducing valve should be 

installed, including a valve-up downstream in the 

supply of compressed air.

DO NOT POINT THE PAINT SPRAY GUN.

Never aim it at yourself or others, being the paint 

spray gun loaded or not.

Never play with the paint 

spray gun, use the paint spray gun as a professio-

nal tool.

STORE PNEUMATIC TOOLS.

Store pneumatic tools out of reach of children and not 

allow the handling of pneumatic tools to people unfa-

miliar with the tools or these instructions.

Pneumatic 

tools are dangerous in the hands of untrained users.

MAINTENANCE.

Check moving parts for misalignment or binding, 

there are no broken parts or other conditions that 

may affect the operation of pneumatic tools.

Pneu-

matic tools are repaired before use when they are 

damaged.

Many accidents are caused by poorly 

maintained pneumatic tools.

Use pneumatic tools, 

accessories and tool tips, etc. according to these 

instructions and in the manner provided for the par-

ticular type of pneumatic tool, taking into account 

the conditions work and work to develop.

The use 

of the pneumatic tool for applications other than 

those intended could result in a dangerous situa-

tion.

Please check your pneumatic tool serviced by 

a Werku

®

 official repair service using only identical 

replacement parts.

This will ensure the safety of the 

pneumatic tool is maintained.

CHECK CONDITION.

Make sure that all the screws in the paint spray gun 

are perfectly tightened.

In cold climates or when 

the paint spray gun has not been used for a period, 

allow the paint spray gun to warm up by leaving it to 

run empty for a few minutes, to ensure that all inter-

nal components are perfectly lubricated.

Make sure 

that the possible installed accessories are perfectly 

fitted in place.

BEFORE STARTING WORK.

Make sure that the suction paint spray gun is firmly 

supported before using.

Check that no one is stan-

ding beneath you when using the suction paint spray 

gun in high areas.

Keep your hands away from all 

moving parts of the suction paint spray gun.

DURING THE OPERATION.

Do not leave the suction paint spray gun operating 

without having it firmly fixed.

Only turn it on when 

you are sure you have full control over it.

Do not 

point the suction paint spray gun at anyone while in 

use.

When operating the suction paint spray gun will 

produce vibrations.

The screws may gradually come 

loose, and possibly cause faults or accidents.

Keep 

your hands away from all moving parts of the suction 

paint spray gun.

AT FINISH WORKING.

Do not touch the possible accessories installed in 

the suction paint spray gun after use.

It may be hot 

and cause burns.

Some materials worked with may