8
5
PROPER USE
HOW TO SETUP POSITIONS
The Telescoping Multiladder can be used in positions shown below with no additional
equipment required. The following instruction will demonstrate how to change the
Telescoping Multiladder.
Position #1
1) To conigure the ladder into the stepladder
position, follow the directions for changing the
angle of the ladder (Section 3) using the push
knob locking hinge.
Note:
The stepladder position is easiest
completed with the ladder standing up. In this
position excess pressure is not exerted on
the hinge.
2) At this point the height of the ladder can be
changed to the desired height using the Spring
Loaded “J” locks and the instructions for them
(Section 4).
• For every position all hinges are supporting hinges and must be locked.
• Never straddle front and rear sections.
• Always face ladder and maintain irm grip while on it.
• DO NOT stand on or above second rung from top of ladder.
CAUTION
Double Sided Stepladder
