Werner R2 Series, User Instructions

Appendix A Auto Coil 2™SRL’s

USER INSTRUCTIONS

Page 9

ENGLISH

                      Read all warnings and instructions in User Manual 
                prior to use and follow accordingly.  If missing, contact 
             Werner Co. for a replacement.  Inspect product prior to each 
         use, then at least monthly by a competent person who is not a user.  
       Before use withdraw and retract some webbing and tug sharply to
    ensure that the pawls engage properly and the unit retracts normally.  
  Avoid exposure to sharp edges, chemicals, or environmental hazards that 
 could weaken the product.  User repairs or alterations are 

NOT

 permitted.

 Only the harness back D-ring (A) to be used for fall arrest.  Verify connectors are 
compatible (see User Manual).  Ensure that the anchorage strength is 
5,000 lbs. (22kN) or more, or certified by a Qualified Person to take 
twice the foreseeable load.  To minimize swing fall, anchor as directly 
above work area as possible. Check for unobstructed clearance beneath.
  Do not permit the lifeline to become slack.  Verify that this product is 
   suitable for the chosen fall protection. See instructions for suitability 
    for horizontral use and horizontal lifeline compatiablity.

       If the stitching is torn, this indicates that the product has seen 
          a fall and should be removed from service.

            See the User Manual for more details.  User must be trained before 
                using this product.

© 2016 Werner Co.
P/N 107101-03
Rev B 10/16

                      Read all warnings and instructions in User Manual 
                prior to use and follow accordingly.  If missing, contact 
             Werner Co. for a replacement.  Inspect product prior to each 
         use, then at least monthly by a competent person who is not a user.  
       Before use withdraw and retract some cable and tug sharply to
    ensure that the pawls engage properly and the unit retracts normally.  
  Avoid exposure to sharp edges, chemicals, or environmental hazards that 
 could weaken the product.  User repairs or alterations are 

NOT

 permitted.

 Only the harness back D-ring (A) to be used for fall arrest.  Verify connectors are 
compatible (see User Manual).  Ensure that the anchorage strength is 
5,000 lbs. (22kN) or more, or certified by a Qualified Person to take 
twice the foreseeable load.  To minimize swing fall, anchor as directly 
above work area as possible. Check for unobstructed clearance beneath.
  Do not permit the lifeline to become slack.  Verify that this product is 
   suitable for the chosen fall protection. See instructions for suitability 
    for horizontral use and horizontal lifeline compatiablity.

       If the red indicator on the snaphook is visible, this indicates that 
          the product has seen a fall and should be removed from service.

            See the User Manual for more details.  User must be trained before 
                using this product.

© 2016 Werner Co.
P/N 107101-04
Rev B 10/16