Rocktab U200 User Manual
119 / 151
2.
Select the desired scan mode from the drop-down menu as shown below.
3.
After selecting a desired scan mode, click "Save to Device" in the sidebar.
Scan mode
Description
Manual Trigger
In manual trigger mode, the scanner scans until a bar code is read or until the trigger
is released. Two modes are available, Normal and Advanced. Normal mode provides
good scanning speed and the longest working ranges (depth of field). Advanced
mode gives you the highest possible scanning speed, but slightly less range than
Normal mode. Advanced mode is best used when you need very high speed and do
not need a large working area. Standard =
Manual Trigger Normal.
Presentation Mode
Presentation mode uses ambient light and scan engine illumination to detect bar
codes. In Presentation Mode, the LEDs remain dimmed until a bar code is
presented to the scan engine, at which time the target device turns on and the LEDs
illuminate to read the code. If the light level in the room is not high enough,
presentation mode may not work properly.
Streaming presentation
mode
In streaming presentation mode, the scan engine's aimer goes off after a short time,
but the scan light stays on all the time to continuously search for bar codes. Two
modes are available, Normal and Advanced. The Normal mode offers a good
scanning speed and the longest working ranges (depth of the field). Advanced mode
gives you the highest possible scanning speed, but slightly less range than Normal
mode. Advanced mode is best used when you need a very high scanning speed and
do not need a large working area.