- -
- 15 -
6.6.2 WITH PROGRAM “EASY MODE” ENABLE
Select required properly ALU program (prog 4 or 5), extract the gauge arm and posistioning the
gauge in the point where you will apply the counterweight on the rim. If you are using prog. 4 the
gauge must be in point “B” Fig.8 , otherwise if you are using prog 5, the gauge must be at the point
“A” Fig.8,
When the machine has stored the data , an acoustic signal , put the arm in rest posistion.
At the end of the spin, apply counterweights as result screen shows. If the machine are using prog.
4 both weight has to be applied manually at 6 o’clock. Otherwise if you are using prog.5 , the
internal spring counterweight has to be applied at 12 o’clock.
ATTENTION:
When “EASY MODE” prog. is enable , the external adhesive counterweight
has to be placed just below of the level flange (Fig.9 ).
Fig. 9 Applying position whit “EASY MODE”
prog. Is enable
