9
EN
ACCESSORIES
WS2972U
WS2972KU
Battery pack (WS9900)
1
1
Charger (WS9918U)
1
1
Double ended bits (PH2 / SL5.5)
1
/
42pc accessories kit
Tape measure(10’/3m)
Magnetic bit holder(2”/50mm)
Pliers
Level
Knife
Screwdriver (flat head / philips)
Spade bits (3/8”,1/2”,5/8”,3/4”,1”)
Metal drill bits (2*1/16”,2*5/64”,2*1/8”,5/32”,3/16”,1/4”,5/16”)
50mm bits (SL4 / SL6,T20 / T25, PH1 / PH2 / PH3, PZ1 / PZ2 / PZ3)
25mm bits (SL4 / SL6,T20 / T25, PH1 / PH2 / PH3, PZ1 / PZ2 / PZ3)
/
1
1
1
1
1
1
2
5
10
10
10
We recommend that you purchase your accessories from the same store that sold you the tool. Refer to the accessory
packaging for further details. Store personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
NOTE:
a) Do not use any charger other than that specifically
provided for use with the equipment.
b) If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
c) The battery in your new tool is not charged when
it leaves the plant. Therefore it must be full charged
before using the first time
d) Please charge the battery to reach full or no less than
half charge before storage. If the tool will not be used
for long periods of time, charge the battery every 3-6
months Charging procedure.
CHARGING PROCEDURE (SEE FIG. A)
1) Connect the battery charger to the power supply and
the indicator light should turn to green.
2) Slide the charger base on the battery pack to make
connections and the indicator light will turn red to show
that the charging has started.
3) When charging is completed, the light will turn
to green. The pack is now fully charged, unplug the
charger and remove the battery pack.
WARNING:
When battery charge runs out after
continuously use or exposure to direct sunlight
or heat, allow time for the tool to cool down before re-
charging to achieve the full charge.
CHARGING INDICATOR
Light
Status
Red ON
Charging
Green ON
Fully charged
B) TO REMOVE THE BATTERY PACK (SEE FIG. B1)
Depress the Battery Pack Release Button firmly first and
then slide the Battery Pack out from your tool.
C) TO INSTALL THE BATTERY PACK (SEE FIG. B2)
Slide the fully charged Battery Pack onto the tool with
sufficient force until it clicks into position.
OPERATION
1. ON / OFF SWITCH (SEE FIG. C)
Depress the On/Off switch to start and release it to stop
your drill.
