16
EN
9. TEMPERATURE DEPENDENT OVERLOAD
PROTECTION
When using as intended for the power tool cannot be subject
to overload. When the load is too high or the allowable battery
temperature of 75°C is exceeded, the electronic control switches off
the power tool until the temperature is in the optimum temperature
range again.
10. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by the
“Discharging Protection System”. When the battery is empty,
the machine is switched off by means of a protective circuit: The
inserted tool no longer rotates.
TROUBLESHOOTING
1. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems and having not used a battery pack for
a prolonged time will reduce the battery pack working time. This
can be corrected after several charge and discharge operations by
charging & working with your driver. Heavy working conditions such
as large screws into hard wood will use up the battery pack energy
faster than lighter working conditions. Do not re-charge your battery
pack below 0
o
C and above 45
o
C as this will affect performance.
2. WHY DOES THE TOOL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the
trigger, is positioned in the lock function. Unlock the forward/
reverse rotation control by putting it into the required rotation
position. Push the trigger and the tool will start to rotate.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free of
dust. Occasionally you may see sparks through the ventilation slots.
This is normal and will not damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of tool and
battery is 0
o
C-45
o
C.
The recommended ambient temperature range for the charging
system during charging is 0
o
C-40
o
C.
Summary of Contents for CIW18BWD
