13
EN
Securely clamp the parallel guide.
NOTE:
It is best to carry out a trial cut.
9. BEVEL CUTS (See Fig. K)
Set the required bevel angle between 0° and 45°. Do not
use the depth of cut scale when making bevel cuts due to
possible inaccuracy.
10. HEX KEY STORAGE
(See Fig. L)
The supplied hex key provided can be placed in the area
under the machine motor.
WORKING HINTS FOR YOUR CIRCULAR
SAW
If your power tool becomes too hot, run your circular saw
no load for 2-3 minutes to cool the motor. Avoid prolonged
usage at very low speeds.
Always use a blade suited to the material and material
thickness to be cut. The quality of cut will improve as the
number of blade teeth increase.
Always ensure the work-piece is firmly held or clamped to
prevent movement. Support large panels close to the cut
line. Any movement of the material may affect the quality
of the cut. The blade cuts on the upward stroke and may
chip the uppermost surface or edges of your work piece.
When cutting, ensure your uppermost surface is a non-
visible surface when your work is finished. Feeding too fast
significantly reduces the performance of the machine and
shortens the life of the saw blade. Always face the good side
of the work-piece down, to ensure minimum splintering.
Only use sharp saw blades of the correct type.
MAINTENANCE
Remove the battery pack before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.
For Battery tools
The ambient temperature range for the use and storage of
tool and battery is 0
o
C (44.6
o
F)-45
o
C (113
o
F).
The recommended ambient temperature range for the
charging system during charging is 0
o
C (44.6
o
F)-40
o
C
(104
o
F).
FCC PART 15
Supplier’s Declaration of Conformity
Product Description: Battery charger
Model Number: WS9924U
Trade Name: WESCO
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Responsible Party :
Positec USA, Inc.
10130 Perimeter Parkway, Charlotte, NC 28216 USA
Tel.: (704) 599-3711
Fax: (704) 599-6390
Summary of Contents for CSC165W
