15
EN
SYMBOLS
OPERATING
INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
CHARGING
A) BATTERY CHARGING
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another battery
charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off
by means of a protective circuit: The tool holder no longer
rotates.
In a warm environment or after heavy use, the battery pack
may become too hot to permit charging. Allow time for the
battery to cool down before recharging.
When the battery is charged for the first time and
after prolonged storage, the battery will only accept
approximately 60% charge. However, after several charge
and discharge cycles the battery will accept a 100% charge.
B) TO REMOVE OR INSTALL BATTERY PACK
(See Fig. A1)
Depress the Battery Pack Release Button to release and
slide the Battery Pack out from your tool. After recharge,
Slide it back into your tool. A simple push and slight
pressure will be sufficient.
C) CHARGING PROCEDURE(See Fig. A2)
NOTE:
a) Do not use any charger other than that specifically
provided for use with the equipment.
b) If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
c) The battery in your new tool is not charged when it
leaves the plant. Therefore it must be full charged
before using the first time.
d) Please charge the battery to reach full or no less than
half charge before storage. If the tool will not be used
for long periods of time, charge the battery every 3-6
months.
1) Plug the charger into an appropriate outlet.
2) Place the battery pack into the charger
3) When charging is completed, unplug the charger and
remove the battery pack.
WARNING:
When battery charge runs out after
continuous use or exposure to direct sunlight or
heat, allow time for the battery to cool down before
recharging to achieve the full charge.
To reduce the risk of injury, user must read
instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Do not dispose of batteries, Return exhausted
batteries to your local collection or recycling
point.
Warning
Do not burn
Do not expose to rain or water
For indoor use only
Fuse
Positive terminal
Negative terminal
Double insulation
xINR18/65-y:
Cylindrical lithium Ion
battery cells with max diameter of 18mm
and max height of 65mm; “x” represents
a number cells serial connected, blank if 1;
“-y” represents a number of cells paralleled
connected, blank if 1.
T2.5A
