13
EN
SYMBOLS
OPERATING
INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for dry sanding–with high removal
capacity of wood, plastic, metal, filler as well as varnished
surfaces.
1. ON/OFF SWITCH (See Fig. A)
Depress to start and release to stop your tool.
2. SWITCH LOCK-ON BUTTON (See Fig. B)
Depress on/off switch then depress lock-on button. Your
tool is now locked on for continuous use. To switch off your
tool just depress and release the on/off switch(9).
3. HAND GRIP AREAS (See Fig. C)
Always hold your belt sander firmly with both hands when
operating.
4. VARIABLE SPEED CONTROL DIAL (See
Fig. D)
Adjust the variable speed control dial to increase or
decrease the speed according to the material and sanding
belt specification to be used (also possible during no load
operation). See the table below for general guidance on
speed selection. Avoid prolonged use at very low speed as
this may damage your sander’s motor.
To reduce the risk of injury, user must read
instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Material
Speed
selection
Belt Grit
Solid Wood
5-6
80
Veneer
2-4
150
Chipboard
1-5
60/80
Plastics
2-5
100
Steel
5-6
80
Paint Removal
6
40/60
Balsa Wood
1-3
100
Acrylic
1-2
100
