Wesco WS4501, Manual

16

EN

SYMBOLS

WARNING-To reduce the risk of injury, user

                 must read instruction manual

Double insulation

Warning

Wear ear protection

Wear eye protection

  Wear dust mask

OPERATING 

INSTRUCTIONS

NOTE:

Before using the tool, read the 

instruction book carefully.

1. PLACE THE BONNET (See Fig. A)

Place the required Bonnet securely over the Velcro Pad and 
make sure it’s centrosymmetric, otherwise the polisher 
vibrates badly.

2. SPREAD THE POLISH (See Fig. B)

Spread about a tablespoonful of polish evenly over the entire 
surface of the bonnet . Do not apply polish directly to car. 
This first application should do about 1/3 of an average 
size car. For the second and third applications of polish, 
repeat as above. The bonnet will not adsorb as much when 
reloading.

3. LOCK-ON SWITCH (See Fig. C)

Depress On/Off Switch (6) then Lock-On Button (5), your 
switch is now locked on for continuous use. To switch off 
your tool just release the On/Off Switch.

4. VARIABLE SPEED CONTROL (See Fig. D) 

The speed increases as you turn the switch towards the 
higher number and decreases on the lower number.

5. HAND GRIP AREAS (SEE FIG. E)

Always hold your car polisher firmly with both hands when 
operating.

6. INSTALLING THE FRONT HANDLE (See 
Fig. F1,F2)

For your personal safety we recommend using the Front 
Handle at all time.
Tighten the screw with hex key clockwise. Tighten fully.

WARNING:
Make sure the protrude (b) on the 

handle locked in the groove (a) of the 
machine to fix the handle.  (See Fig. F2)

7. SPINDLE LOCK BUTTON (SEE FIG. G)

Press in the Spindle Lock Button and rotate the Velcro Pad 
by hand until it is locked.

ATTENTION: 

The spindle lock button must only 

be used when changing a pad. Never press it when 

the pad is rotating.

Remove the plug from the socket before 
carrying out the adjustment.