Wesco WS4501, Manual

17

EN

8. TO REPLACE THE BRUSHES (See Fig. H)

Remove the Brush Holder out directly by screwing the 
screwdriver. Check the length of the brush and replace if 
under 7mm. When brushes need replacement always renew 
both brushes, even if one is still more than 7mm long. Put 
the Brush Holder into the body. Tighten the Brush Holder.
Check the tool is working before use, allow it run for a few 
minutes to enable the brushes to be stable.

9. TO USE THE CAR POLISHER (See Fig. I)

Hold extension cord over the shoulder and do flat surfaces 
first, i.e.: bonnet boot and roof. Cover areas quickly with 
broad sweeping strokes in a crisscross pattern. Do not press 
down on polisher. The machine without any pressure will 
automatically do the best job.

10. FINAL WORK (See Fig. J)

Use long, sweeping strokes in a criss-cross pattern to bring 
out the shine. Do not over-press the polisher.

WORKING HINTS FOR 

YOUR POLISHER

1.   At all times, let the polisher do the work-do not force it 

or apply excessive pressure to the polisher. Preferably, 
use a light circular motion. Pressing too hard will slow 
down the machine’s movement and affect the quality of 
the work.

2.   The most common error, however, is applying too much 

wax. If pad absorbs too much wax, it will not last as 
long, and polishing is more difficult and takes longer.

3.   If bonnet continually comes off pad, please try with a 

new bonnet.

4.   If wax seems difficult to buff, you may have used too 

much wax.

MAINTENANCE

Remove the plug from the socket before 
carrying out any adjustment, servicing or 
maintenance.

Your power tool requires no additional lubrication or 
maintenance. There are no user serviceable parts in your 
power tool. Never use water or chemical cleaners to clean 
your power tool. Wipe clean with a dry cloth. Always store 
your power tool in a dry place. Keep the motor ventilation 
slots clean. Keep all working controls free of dust. 
Occasionally you may see sparks through the ventilation 
slots. This is normal. 
If the supply cord is damaged, it must be replaced by the 

manufacturer, its service agent or similarly qualified persons 
in order to avoid a hazard. 

TROUBLESHOOTING

1.   If your power tool does not start, check the plug on the 

power supply first.

2.   If the polisher does not abrade surface, checking the 

bonnet. If the bonnet has been worn, replace the new 
bonnet and try again.

3.   If a fault can not be rectified, return the tool to an 

authorized dealer for repair.