5
M10 Split
Washer (45)–2
M10 Locknut
(33)–2
M10
Washer (83)–2
M8 Locknut
(38)–8
M8 x 43mm Button Bolt (50)–6
M10 x 25mm
Patch Screw (40)–2
M10 x 78mm Button Bolt (34)–4
Small Wave
Washer (69)–2
M8 Split
Washer (28)–6
M8 x 25mm Patch
Screw (56)–2
M8 Washer
(55)–8
M8 x 80mm Patch Bolt (79)–2
M6 Bolt Set (25)–2
Large Wave
Washer (76)–2
M10 x 74mm Button Bolt (7)–2
M4 x 10mm
Blunt Screw
(82)–2
M4 x 16mm
Self-tapping
Screw (52)–10
M6 x 13mm
Patch Screw
(81)–2
M8 x 14mm Button
Screw (27)–6
ASSEMBLY
Assembly requires two persons.
Place all parts of the elliptical exerciser in a cleared area and remove all
packing materials; do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
, an adjustable
wrench
, and a rubber mallet
.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly.
Note: If a part is not in the hardware
kit, check to see if it has been preassembled.