Weslo CADENCE 26.0, User Manual

20

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and 

follow the steps listed. If further assistance is needed, please see the front cover of this manual. 

PROBLEM:  The power does not turn on

SOLUTION: a.    Make sure that the power cord is plugged into a properly earthed outlet (see page 13). If an 

extension cord is needed, use only a 3-conductor, 14-gauge (1 mm

2

) cord that is no longer than 5 

ft. (1.5 m).

b. After the power cord has been plugged in, make sure that the key is inserted into the console. 

c.    Check the power switch located on the treadmill 

frame near the power cord. If the switch protrudes 

as shown, the switch has tripped. To reset the 

switch, wait for five minutes and then press the 

switch back in. 

PROBLEM:  The power turns off during use

SOLUTION: a.  Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes 

and then press the switch back in.

b.  Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five 

minutes, and then plug it back in.

c.  Remove the key from the console. Reinsert the key into the console.

d. If the treadmill still will not run, see the front cover of this manual.

PROBLEM:  The console displays remain lit when you remove the key from the console

SOLUTION: a.  The console features a display demo mode, designed to be used if the treadmill is displayed in a 

store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off 

the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE 

INFORMATION MODE on page 18 to turn off the demo mode.

PROBLEM:   The incline of the treadmill does not change correctly 

SOLUTION:  a.  With the key in the console, press one of the Incline buttons. While the incline is changing, 

remove the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the 

maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM:  The displays of the console do not function properly

SOLUTION: a.  Remove the key from the console and UNPLUG THE 

POWER CORD. Next, remove the two #12 x 1 1/4” 

Screws (27) and the two #8 x 3/4” Hood Screws (24) 

and carefully remove the Motor Hood (62).

Tripped

c

24

27

27

62

a

TROUBLESHOOTING

Reset