9
6. Have a second person hold the console assem-
bly near the Right Upright (78).
Connect the wire harness on the console assem-
bly to the Upright Wire (74) as shown in the inset
drawing. The connectors should slide together
easily and snap into place. If they do not, turn
one connector and try again. IF YOU DO NOT
CONNECT THE CONNECTORS PROPERLY,
THE CONSOLE MAY BECOME DAMAGED
WHEN YOU TURN ON THE POWER.
Remove the wire tie from the Upright Wire (74).
5
5
78
2
2
2
5
7. Insert the wires into the Right Upright (78). Next,
insert the brackets on the console assembly into
the Right Upright and the Left Upright (77). Be
careful not to pinch any wires.
Attach the console assembly with four 5/16” x
3/4” Bolts (2) and four 5/16” Star Washers (5).
Start all four Bolts, and then firmly tighten
each of them.
77
Console
Assembly
7
2
8. Set the Left Handrail (69) and the Right Handrail
(71) on a level surface.
Attach the Handrails (69, 71) to the Handrail
Bracket (70) with four 1/4” x 1 1/2” Bolts (3)
and four 1/4” Nuts (4). See the lower drawing.
Make sure that the Nuts sit inside the indi-
cated square holes in the Handrails. Start all
four Bolts, and then tighten each of them.
Console
Assembly
78
6
74
Wire
Tie
74
Wire
Harness
8
3
3
4
4
4
4
69
70
71
Square Holes
69
71
