Weslo Cadence 900 Treadmill, User Manual

17

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION:

a. Make sure that the power cord is plugged into a properly earthed outlet (see page 10). If an exten-

sion cord is needed, use only a 3-conductor, 1 mm

2

(14-gauge) cord that is no longer than 1.5 m

(5 ft.). Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill

near the power cord. If the switch protrudes as
shown, the circuit breaker has tripped. To reset the
circuit breaker, wait for five minutes and then press
the switch back in. 

d. Check the on/off switch located on the treadmill

near the power cord. The switch must be in the
“on” position.

PROBLEM: The power turns off during use

SOLUTION:

a. Check the circuit breaker located on the treadmill near the power cord (see c. above). If the cir-

cuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for

five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key fully into the console. 

d. Make sure that the on/off switch is in the “on” position (see d. above).

e. If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The displays of the console do not function properly

SOLUTION:

a. Remove the key from the console and 

UNPLUG THE

POWER CORD.

Remove the four 3/4” Tek Screws

(9) from the Hood (1), and carefully remove the Hood.

9

1

a

Tripped

c

Reset

On

Position

d