15.
Make sure that all parts are properly tightened before you use the treadmill.
Keep the included hex keys
in a secure place. A hex key is used to adjust the walking belt (see page 20). To protect the floor or carpet,
place a mat under the treadmill.
13. Attach the Latch Housing (48) to the Left Upright
(53) with two 18mm Screws (58);
start both
Screws before tightening either of them.
58
48
53
13
14. Raise the treadmill to the storage position (see
HOW TO FOLD THE TREADMILL FOR STOR-
AGE on page 17). Attach an Incline Leg (95) to
each side of the Frame (51) with an M8 x 52mm
Bolt (82), two M8 Flat Washers (72), and an M8
Nut (46) as shown.
Note: Do not overtighten
the Nuts. The Incline Legs should be able to
rotate easily.
Adjust the Incline Legs (95) to the desired in-
cline (see page 16).
Lower the treadmill (see HOW TO LOWER THE
TREADMILL FOR USE on page 18).
95
72
82
46
72
72
46
95
82
72
14
12. Lower the Uprights (53, 54).
See the lower
drawing.
Position the Uprights so that the tread-
mill Frame (51) is centered between the
Uprights.
Firmly tighten the two M10 x 110mm Bolts (1)
and the four M10 x 58mm Bolts (2).
Be careful
not to overtighten the M10 x 110mm Bolts.
Raise the Uprights (53, 54) to the vertical posi-
tion.
12
2
51
1
53
51
54
Top View
11
51
