3. With the help of a second person, hold the Console Base
(6) and the Right Handrail (57) near the right Upright (14)
as shown. Insert all excess Wire Harness (26) into the
Handrail and down into the right Upright; bend the Wire
Harness, if necessary.
Cut the plastic tie holding the cage nut in the Handrail (57).
Next, make sure the Wire Harness is in the bracket on the
Right Handrail and insert the bracket into the right Upright.
Make sure that the Wire Harness is not pinched.
4. Position the Right Handrail (57) on the right Upright (14).
Attach the lower end of the Right Handrail first.
Thread
a Handrail Bolt (15) with a Handrail Washer (32) into the
lower end of the Right Handrail and the right Upright.
Do
not tighten the Handrail Bolt yet.
Attach the upper end of the Right Handrail (57) to the right
Upright (14) with a Handrail Bolt (15) and Handrail
Washer (32).
Do not tighten the Handrail Bolt yet.
5. Attach the Console Base (6) to the Left and Right
Handrails (2, 57) with four Screws (55).
Tighten all parts used in this step and in steps 2 and
4.
6. Attach the Storage Latch (12) to the left Upright (14) with
two Latch Screws (59).
Be careful not to overtighten
the Screws.
7. Remove the backing from the Adhesive Clip (74). Press
the Adhesive Clip onto the base of the Uprights (14) in
the indicated location. Press the Allen Wrench (73) into
the Adhesive Clip.
8.
Make sure that all parts are tightened before you use
the treadmill.
To protect the floor or carpet, place a mat
under the treadmill.
6
26
Bracket
Plastic Tie
57
14
3
6
15
15
32
32
14
57
4
55
6
55
2
57
5
59
12
14
6
73
74
14
7
