6
ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call 1-800-445-2480. Assembly
requires only the included hex key and wrench
.
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials.
Do not
dispose of the packing materials until assembly is completed. Note: Some small parts may have been
pre-assembled. To avoid damaging parts, do not use power tools for assembly. Extra hardware may be
included.
The number in parentheses in the drawing below is the key number of the part, from the PART LIST
near the end of this manual. The number after the parentheses is the quantity needed for assembly.
M8 Nylon
Nut (13)–4
M8 x 50mm Bolt
(38)–4
M5 x 10mm Bolt
(10)–2
M8 x 15mm Bolt
(33)–4
M8 Washer
(34)–4
M4 x 12mm
Screw (3)–2
M8 Curved
Washer (37)–4
38
13
13
37
37
38
Hole
Holes
Holes
1
1. Identify the Right Upright (36), which has a single hole
in the indicated location. (Note: There is a wire inside of
the Left Upright [35].) Hold the Right Upright against the
Base (14) as shown, and orient the Right Upright so the
two indicated holes are on the side shown.
Attach the Right Upright (36) to the Base (14) with two
M8 x 50mm Bolts (38), two M8 Curved Washers (37),
and two M8 Nylon Nuts (13) as shown. Make sure that
the curved sides of the Washers are against the Base.
Do not tighten the Nylon Nuts yet.
Attach the Left Upright (35) to the Base (14) in the
same way. Make sure that the Left Upright is oriented
so the two indicated holes are on the side shown.
Do
not tighten the Nylon Nuts yet.
2. Raise the Left Upright (35) and the Right Upright (36) to
the position shown.
2
35
36
36
35
14
37
37
