9
3.
Wipe out the spa shell using a damp cloth. Remove
the two warning decals (not shown) from the spa
shell. Before you fill the spa, be sure that it is in the
position you want, and that it can be easily ser-
viced, if needed. Once the spa is filled with water, it
must be drained to be moved.
Using a garden hose or other clean water source,
begin filling the spa.
Do not use soft water.
The
water temperature does not matter; however, if you
use warm or hot water, the spa will be ready to use
sooner. Fill the spa until the water is about four
inches below the console.
Do not overfill the spa.
4.
Place the Spa Cover (18) over the spa.
Make sure
the Spa Cover is properly centered.
Snap a Buckle (2) onto each of the four latches on
the Spa Cover (18).
See the inset drawing. Position one of the Buckles
(2) on the wood panels on the Spa Unit (15). Hold
the Buckle in place so the strap on the Spa Cover
(18) is tight. (Note: It may be easier to position the
Buckle if a second person holds the strap on the
opposite side of the Spa Cover tight.)
The Spa
Cover must be tight. Do not place the Buckle
over one of the grooves in the wood panels.
Remove the latch. Attach the Buckle to the side of
the spa with two Buckle Screws (1).
Note: It may
be helpful to use a drill with a 1/16Ó drill bit to
make starter holes in the wood panels. You may
also want to apply a little soap or wax to the
screw threads.
Attach the other three Buckles (2) to the Spa Unit
(15) in the same manner.
Remove the Spa Cover (18) from the Spa Unit (15).
Fill to Here
3
4
18
15
15
2
2
1
Strap
Latch
5.
Before using the spa, refer to the instructions on page 14 and post the included warning sign.
Do not
allow the spa to be used before the warning sign is posted.
