15
Inspect and properly tighten all parts of the elliptical
exerciser regularly. Replace any worn parts immedi-
ately. The elliptical exerciser can be cleaned with a
soft cloth and mild detergent–
do not use abrasives
or solvents.
To prevent damage to the console, keep
liquids away from the console and keep the console
out of direct sunlight.
When storing the elliptical exerciser, remove the bat-
teries from the console. Keep the elliptical exerciser in
a clean, dry location, away from moisture and dust.
CONSOLE TROUBLESHOOTING
If the console does not function properly, the batteries
should be replaced. To replace the batteries, see
assembly step 8 on page 8.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper-
ly, make sure that your hands are positioned as
described in step 5 on page 11. Be careful not to
move your hands excessively or to squeeze the metal
contacts too tightly. For optimal performance, clean
the metal contacts using a soft cloth;
never use alco-
hol, abrasives, or chemicals to clean the contacts.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. First, remove all of
the screws from both side shields;
there are three
sizes of screws in the side shields—note which
size of screw you remove from each hole.
Next, locate the Reed Switch (47). Turn the Flywheel
(48) until the Magnet (53) is aligned with the Reed
Switch. Loosen, but do not remove, the indicated
M4 x 16mm Screw (60). Slide the Reed Switch slight-
ly closer to or away from the Magnet, and then
retighten the Screw. Rock the Flywheel forward and
backward just enough that the Magnet passes the
Reed Switch repeatedly. Repeat until the console dis-
plays correct feedback. When the Reed Switch is cor-
rectly adjusted, reattach the side shields. Note: If you
have questions as to which screw should be in which
hole, see EXPLODED DRAWING B on page 19 and
the PART LIST on page 17.
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance of the pedals is at the high-
est setting, the Belt (37) may need to be adjusted.
First, remove all the screws from both side shields;
there are three sizes of screws in the side
shields—note which size of screw you remove
from each hole.
Next, loosen the M8 x 19mm Flat Head Bolt (61) and
turn the Adjustment Screw (62) until the Belt (37) is
tight. Once the Belt is tight, tighten the Flat Head
Screw. Then, reattach the side shields. Note: If you
have questions as to which screw should be in which
hole, see EXPLODED DRAWING B on page 19 and
the PART LIST on page 17.
MAINTENANCE AND TROUBLESHOOTING
48
53
60
47
61
37
62
