5
Use the chart below to identify the small parts used in assembly. The number in parenthesis below each part
refers to the key number of the part, from the PART LIST on page 14. The number after the dash indicates the
quantity needed for assembly. Note: Some parts may have been pre-attached for shipping. If a part is not
in the parts bag, check to see if it has been pre-attached.
Console
Screw (69)–4
M8 Nylon
Locknut (67)–4
M10 Nylon
Locknut (61)–4
M10 Split
Washer (14)–10
M4 x 19mm Flange
Screw (73)–6
M8 Split
Washer (20)–2
M6 Split
Washer (58)–4
M8 x 19mm
Patch Screw (62)–2
M6 x 16mm Button
Screw (55)–4
M10 x 25mm
Button Screw (56)–10
M8 x 36mm
Button Bolt (66)–4
M10 x 75mm
Carriage Bolt (64)–4
M8 Flat
Washer (48)–2
M8 x 45mm
Button Screw (65)–2
M4 x 10.5mm
Screw (70)–1
ASSEMBLY
Assembly requires two people. Place all parts of the elliptical trainer in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included allen wrench, assembly requires a phillips screwdriver , two adjustable
spanners , a rubber mallet , and a pair of pliers .
1
1
61
64
16
61
1. Identify the Rear Stabiliser (16), which is the longer of
the two Stabilisers. Whilst another person lifts the
back of the Frame (1) slightly, attach the Rear
Stabiliser to the Frame with two M10 x 75mm
Carriage Bolts (64) and two M10 Nylon Locknuts (61).
