7
46
3
22
Handle
17
44
49
5
48
60
47
Welded
Brackets
6
5. Press a 45mm Square Inner Cap (44) into the top
of one of the Press Arms (46). Press a 25mm
Round Inner Cap (49) into each end of the handle
on the Press Arm. Attach the Press Arm to one
side of the Press Frame (17) with two M8 x
63mm Bolts (22) and two M8 Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
6. Identify the Left Arm (47) and Right Arm (48).
Note the position of the welded bracket on each
Arm.
Arm identification is important for step 7.
Press a Butterfly Arm Bushing (60) into each Arm.
4. Press a 25mm Plastic Bushing (26) onto each
welded spacer on the Press Frame (17). Slide the
Press Frame onto the Base (4) so the Plastic
Bushings are aligned with the indicated tube in
the base.
Note: This will be a tight fit; the
Plastic Bushings should fit over the ends of
the tube in the Base.
Lubricate an M10 x 198mm Bolt (59). Attach the
Press Frame (17) to the Base (4) with the Bolt, two
M10 Washers (9), and an M10 Nylon Locknut (21).
Note: Do not overtighten the Nylon Locknut;
the Press Frame must be able to pivot easily.
4
4
Tube
Welded
Spacers
17
Lubricate
21
9
26
9
59
ARM ASSEMBLY
Summary of Contents for Gym 1000
Page 20: ...20 NOTES ...
Page 21: ...21 NOTES ...
Page 26: ... V Pulley 6 Not shown to scale 90mm Pulley 15 Not shown to scale ...
