11
15.
Identify the Press Cable (49).
Slide the Cable
onto the hook on the Left Arm (7).
16. Apply grease to an M10 x 78mm Bolt (54).
Attach a Pulley Arm (38) to the Upright (3) with
the Bolt and an M10 Nylon Locknut (68).
Do
not overtighten the Nylon Locknut; the
Pulley Arm must pivot easily.
Route the Press Cable (49) over a 90mm
Pulley (34). Attach the Pulley, a Cable Trap
(36), an M10 Washer (70), and two Finger
Guards (35) to the indicated side of the Pulley
Arm (38) with an M10 x 52mm Bolt (52) and an
M10 Nylon Locknut (68).
Make sure that the
Cable Trap is oriented to hold the Cable in
the groove of the Pulley.
14. Attach the end of the High Cable (50) to the
Small “U”-bracket (11) with an M8 Washer (71)
and an M8 Nylon Locknut (69).
Note: Do not
completely tighten the Nylon Locknut; it
should be threaded onto the Cable so that
two threads show past the Nylon Locknut,
as shown in the inset drawing.
Attach the Small “U”-bracket (11) to the Weight
Tube (12) with an M8 x 45mm Bolt (60) and an
M8 Nylon Locknut (69).
Do not overtighten
the Nylon Locknut; the Weight Tube must
pivot easily in the Small “U”-bracket.
14
50
11
71
60
69
69
12
7
35
35
34
68
16
50
69
11
49
Hook
70
49
36
38
52
54
3
15
17. Route the Press Cable (49) under a 90mm
Pulley (34). Attach the Pulley and two Finger
Guards (35) to the Double “U”-bracket (42) with
an M10 x 46mm Bolt (53) and an M10 Nylon
Locknut (68).
34
53
68
49
35
42
35
17
Summary of Contents for Gym 650
Page 20: ...20 NOTES ...
