6
2. Have a second person lift the back of the
Frame (1).
Attach the Rear Stabilizer (28) to the Frame (1)
with two M10 x 75mm Carriage Bolts (34) and
two M10 Locknuts (33).
34
28
1
33
33
3. The Console (23) requires four “AA” batteries
(not included); alkaline batteries are recom-
mended.
IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the console displays or other electronic
components.
Press the tab on the battery door and remove
the battery door. Insert four batteries into the
Console (23) as shown.
Make sure that the
batteries are oriented as shown by the dia-
gram on the battery door.
Then, reattach the
battery door.
4. Have a second person hold the Console (23)
near the Upright (2).
Connect the console wire to the Upper Wire
Harness (44). Insert the console wire and the
Upper Wire Harness downward into the Upright
(2).
Tip: Avoid pinching the console wire and the
Upper Wire Harness (44).
Attach the Console
(23) to the Upright (2) with four M6 x 18mm
Screws (43).
4
23
2
44
Console Wire
43
23
Batteries
Battery
Door
Tab
3
Avoid pinching
the console wire
and the Upper
Wire Harness (44)
2
