7
50
8
27
6. Identify the Left Handlebar (6), which is marked with
a “Left” sticker. Insert the Left Handlebar into one of
the Handlebar Arms (5);
make sure that the
Handlebar Arm is turned so the hexagonal holes
are on the indicated side
. Attach the Left
Handlebar with two M6 x 38mm Button Bolts (50)
and two M6 Locknuts (27).
Make sure that the
Locknuts are inside the hexagonal holes. Do not
fully tighten the Button Bolts yet.
Apply a small amount of the included grease to the
left axle on the Upright (2).
Make sure that there are two Small Handlebar
Bushings (49) in the Left Handlebar (6). Slide a
Handlebar Spacer (47) and the Left Handlebar onto
the left axle on the Upright (2) as shown.
Make sure
that the Handlebar Spacer is turned so the curved
side is facing the Upright.
Then, tap an Axle Cap
(14) onto the axle.
Repeat this step to assemble the Right
Handlebar (8) and the other Handlebar Arm (5).
Grease
6
47
14
49
5
2
5
6
Hexagonal
Holes
5
1
2
33
Avoid pinching
the wires
44
66
48
59
5. While another person holds the Upright (2) near the
Frame (1), connect the Upper Wire (44) to the
Lower Wire Harness (66).
Push the excess wire downward into the Frame (1).
Slide the Upright (2) onto the Frame.
Tip: Avoid pinching the Upper Wire (44) and the
Lower Wire Harness (66).
Attach the Upright (2)
with two M10 x 68mm Button Bolts (48), two M10
Split Washers (59), and two M10 Locknuts (33).
Do
not tighten the Button Bolts yet.
