8
9.
Make sure that all parts of the elliptical exerciser are properly tightened.
Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
8. Apply a small amount of grease to the axle on the
left Disc Crossbar (16). Slide the Left Pedal Arm
(11) onto the axle, and then place a Wave Washer
(64) on the end of the axle. Next, slide an M10
Washer (35) onto an M10 x 25mm Patch Screw (22)
and tighten the Patch Screw into the axle.
Hold the lower end of the left Handlebar Arm (5)
inside the bracket on the Left Pedal Arm (11). Next,
apply grease to a Pedal Arm Bolt Set (40). Attach
the Left Pedal Arm to the left Handlebar Arm with
the Bolt Set.
Do not overtighten the Bolt Set; the
Handlebar Arm must pivot freely.
Attach the Right Pedal Arm (not shown) to the right
side of the elliptical exerciser in the same way.
See step 5.
Tighten the M10 x 68mm Button Bolts
(48).
See step 6.
Tighten the M6 x 38mm Button Bolts
(50) in the Handlebar Arms (5).
Grease
Grease
22 35
11
5
8
16
40
40
64
7
36
11
13
7. Identify the Left Pedal Arm (11), which is marked
with a “Left” sticker. Attach a Pedal (13) to the Left
Pedal Arm with two M6 x 45mm Flat Head Screws
(36).
Attach the other Pedal (not shown) to the Right
Pedal Arm (not shown) in the same way.
