5
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the
included allen wrenches, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each
drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is
the quantity needed for assembly.
Note: Some small parts may have been pre-assembled. If a part is not in
the parts bag, check to see if it has been pre-assembled.
M10
Washer (35)–2
M10 Split
Washer (59)–2
M10 Nylon
Locknut (33)–6
Pedal Arm Bolt Set (40)–2
M8 Nylon
Locknut (38)–4
M10 x 25mm
Patch Screw (22)–2
M10 x 75mm Carriage Bolt (34)–4
M10 x 68mm Button Bolt (48)–2
M8 x 38mm Button Bolt (50)–4
M6 x 48mm Flat Head
Screw (36)–4
M8 x 16mm Button
Screw (68)–2
M8 Split
Washer (69)–2
1. Identify the Front Stabilizer (10), which is narrower than
the Rear Stabilizer (not shown). While another person
lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with two M10 x 75mm Carriage
Bolts (34) and two M10 Nylon Locknuts (33).
10
33
34
1
1
