9
9
23
Screw
Batteries
Battery Cover
9. The Console (23) requires four AA batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents.
Remove the battery cover and insert the
batteries into the battery compartment.
Make
sure to orient the batteries as shown by the
diagram inside the battery compartment.
Then, reattach the battery cover.
8. Identify the Left and Right Handlebars (85, 86),
which are marked with “Left” and “Right” stick-
ers.
Have a second person hold the Left and Right
Handlebars (85, 86) near the Upright (2).
See the inset drawing.
Locate the wire tie in
the right side of the Upright (2). Tie the lower
end of the wire tie to the right Pulse Wire (84).
Then, pull the upper end of the wire tie upward
out of the top of the Upright.
Repeat this
action on the left side of the Upright.
Tip: Avoid pinching the wires.
Attach the Left
and Right Handlebars (85, 86) to the Upright (2)
with two M8 x 80mm Bolts (79) and two M8
Locknuts (38).
8
85 38
86
79
86
2
84
84
38
Wire Tie
Wire Tie
2
Avoid pinching
the wires
84
Meijer.com
