15
Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap.
IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries.
See assembly step 12 on page 11 for replacement
instructions.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, first remove the three indicated
ST4.2 x 12mm Self-tapping Screws (66) and the three
indicated ST4.2 x 20mm Self-tapping Screws (68).
Next, carefully pull the Right Shield (4) outward and
upward until you can reach the Idler Adjustment Bolt
(34).
Be careful to avoid scratching the Right Shield
on the Right Thin Locknuts (36).
Next, loosen the M10 Nut (70), and turn the Idler
Adjustment Bolt (34) counterclockwise until the Drive
Belt (19) is tight. Then, retighten the Nut.
See the drawing at the left.
Reattach the Right Shield
(4) with the three ST4.2 x 12mm Self-tapping Screws
(66) and the three ST4.2 x 20mm Self-tapping Screws
(68).
MAINTENANCE AND TROUBLESHOOTING
66
66
66
68
68
68
4
7
4
36
34
70
19
