20
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
drive belt may need to be adjusted.
To adjust the drive belt, first
see assembly step 10 on
page 11
and remove the Right Pedal Arm (51) from
the right Upper Body Leg (44) and the right side of the
Crank (3).
Next,
see the EXPLODED DRAWING on page 23.
Remove the M4 x 50mm Screws (22) and the M5 x
16mm Screws (23) from the Left and Right Shields
(20, 21);
note which size of Screw you remove from
each hole.
Then, gently remove the Right Shield.
Loosen the two M8 Locknuts (29) on the two M8 x
16mm Bolts (30). Then, tighten the M10 x 35mm Screw
(31) until the Drive Belt (5) is tight. When the Drive Belt
is tight, tighten the two Locknuts.
Then, reattach the right shield and the right pedal arm.
31
30
29
5