8
3
4
38
57
14
59
16
3. Attach the Front Stabilizer (38) to the Frame (16)
with two M8 x 65mm Carriage Bolts (57), two
M8 Curved Washers (14), and two M8 Acorn
Nuts (59) (only one side is shown);
start both
Carriage Bolts, and then tighten the Acorn
Nuts.
4. While a second person holds the Upright (32)
near the Frame (16), connect the Upright Wire
(33) to the Reed Switch Wire (18).
Next, push the Lower Resistance Cable (24)
upward into the Upright (32), and then pull the
end of the Lower Resistance Cable out of the
indicated hole.
32
24
18
16
33
Hole