9
6
5. Insert the excess wire and cable into the
Frame (16).
Tip: Avoid pinching the wire and the cable.
Slide the Upright (32) onto the Frame (16).
Attach the Upright (32) with four M8 x 16mm
Screws (15) and four M8 Curved Washers (14);
start all the Screws, and then tighten them.
5
Avoid pinching
the wire and
the cable
32
15
15
15
14
14
15
16
Avoid pinching
the cable
24
32
35
34
6. Connect the Resistance Cable (34) to the Lower
Resistance Cable (24) in the following way:
See drawing A.
Pull upward on the metal
bracket (A) on the Lower Resistance Cable (24),
and insert the tip of the Resistance Cable (34)
into the wire clip inside the metal bracket.
See drawing B.
Firmly pull the Resistance
Cable (34) upward and slide it into the top of the
metal bracket (A).
See drawing C.
Using pliers, squeeze the
prongs on the upper end of the metal bracket (A)
together.
Then, attach the Resistance Control (34) to the
Upright (32) with an M5 x 14mm Screw (35).
A
B
C
24
34
34
A
A
A
