ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.
Assembly requires two persons.
Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires an adjustable wrench
, a Phillips
screwdriver
, and pliers
.
Use the drawings below to identify the small parts used for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly.
Note: If a part is not in the hardware kit, check to see if
it has been preassembled.
5
M10 x 60mm Button
Screw (33)–2
M8 x 20mm
Button Screw (34)–3
M8 Split
Washer (42)–3
M8 Washer
(47)–4
M8 x 55mm Button
Screw (30)–4
M4 x 25mm Self-tapping
Screw (41)–3
M8 Locknut
(10)–4
M4 x 15mm
Screw (27)–4
1. Orient the Rear Stabilizer (6) with the “Up” sticker
facing upward. Slide the Rear Stabilizer into the
Frame (1). Attach the Rear Stabilizer with four M8 x
55mm Button Screws (30).
6
30
1
1
All manuals and user guides at all-guides.com
