8
8. While another person holds the Upright (13) in
the position shown, connect the Extension Wire
(52) to the Reed Switch Wire (43).
Next, connect the Resistance Cable (19) to the
Lower Cable (45) in the following way:
•
See drawing A
. Pull upward on the metal
bracket on the Lower Cable (45), and insert
the tip of the Resistance Cable (19) into the
wire clip inside the metal bracket as shown.
•
See drawing B.
Firmly pull the Resistance
Cable (19) upward and slide it into the top of
the metal bracket as shown.
•
See drawing C.
Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
Push the excess wire and cable downward into
the Frame (1), and insert the Upright (13) into
the Frame.
Tip: Avoid pinching the wires and cables.
Attach the Upright (13) to the Frame (1) with
three M8 x 20mm Button Screws (34) and three
M8 Split Washers (42).
A
B
C
45
19
19
Metal
Bracket
Metal
Bracket
45
1
13
45
19
52
34
34
42
42
8
43
7. Attach the Seat (12) to the Seat Brackets (14,
15) with four M6 x 35mm Button Screws (61)
and four M6 Washers (68).
7
12
68
61
68
68
15
14
61
Avoid pinching
the wires
Summary of Contents for PURSUIT 360R
Page 17: ...17 NOTES ...