Weslo Pursuit 93, User Manual

4

ASSEMBLY

Assembly requires two persons. 

Place all parts of the exercise cycle in a cleared area and remove the packing

materials. Do not dispose of the packing materials until assembly is completed.  

Assembly requires the included tools and your own adjustable spanner                      , Phillips screw-
driver                      , and pliers                      . 

Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below 
each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers
to the quantity needed for assembly. 

Note: Some small parts may have been pre-attached for shipping. If a

part is not in the parts bag, check to see if it has been pre-attached.

3/8” Nylon

Locknut (33)–4

M8 Nylon

Locknut (10)–3

M8 Flat

Washer (51)–3

Ground

Screw (27)–1

M5 x 12mm

Screw (49)–4

3/8” x 78mm Carriage Bolt (30)–4

M8 Lock

Washer (20)–6

M8 Curved

Washer (39)–6

M8 x 15mm

Screw (41)–6

1. Whilst another person lifts the front of the Frame (1),

attach the Front Stabiliser (2) to the Frame with two
3/8” x 78mm Carriage Bolts (30) and two 3/8” Nylon
Locknuts (33) as shown. 

Make sure that the Front

Stabiliser is turned so the Wheels (23) are not
touching the floor.

2

23

23

33

30

1

1

2. Whilst another person lifts the rear of the Frame (1),

attach the Rear Stabiliser (6) with two 3/8” x 78mm
Carriage Bolts (30) and two 3/8” Nylon Locknuts (33). 

30

6

1

2

33

33