7
7. Attach the Stabilizer (30) to the Seat Frame (2) with
two M10 x 70mm Carriage Bolts (27) and two M10
Nylon Locknuts (26).
8. Attach the Seat Bracket (63) to the Seat Upright
(64) with four M8 x 66mm Carriage Bolts (52), four
M8 Flat Washers (51), and four M8 Nylon Locknuts
(55).
52
63
55
51
51
64
2
30
27
7
8
26
26
6. Attach the Seat Upright (64) to the Seat Frame (2)
with four M8 x 54mm Carriage Bolts (11), four M8
Flat Washers (51), and four M8 Nylon Locknuts (55).
Note: It may be helpful to tip the exercise cycle on
its side to attach the Seat Upright.
11
11
64
2
55
51
51
55
6
5
3
42
22
69
33
32
43
43
31
5. Connect the Reed Switch Wire (42) to the corre-
sponding console wire. Attach the ground wire to the
Upright (3) with an M4 x 8mm Screw (22). Connect
the Pulse Wires (69) to the corresponding console
wires. Insert the excess wire into the Upright.
Attach the Console (33) to the Upright (3) with four
M4 x 16mm Screws (43). Be careful not to pinch
the wires or the cable. Press the Resistance Knob
(32) onto the Resistance Control (31). Make sure
that the mark on the Resistance Knob is correctly
aligned.
Console
Wire
Ground
Wire
Console
Wires
Be careful not to
pinch the wires
or the cable.
