12
HOW TO ADJUST THE BELT
The exercise cycle features a precision belt that must
be kept properly adjusted. If the belt causes exces-
sive noise or slips as you pedal, the belt should be
checked. To do this, the left side shield must first be
removed. See the instructions on page 11 and
remove the left
side shield.
Next, use an
adjustable
wrench to turn
the right pedal
counterclock-
wise and
remove it.
Remove the
right side
shield.
Press down on
the center of the Belt (16) between the front and rear
sprockets.
There should be from 1/4” to 3/4” of ver-
tical movement in the center of the Belt.
If the Belt (16) is properly adjusted, reattach the side
shields and pedals. If the Belt needs to be adjusted,
loosen the M8 Washer Nut (37) on each side of the
Flywheel (32).
To tighten the
Belt, turn the
two M6 Stop
Nuts (47) clock-
wise; to loosen
the belt, turn
the Nuts coun-
terclockwise.
Make sure that
the Flywheel is
straight and
tighten the M8
Washer Nuts (37). Reattach the side shields and
pedals.
16
16
32
37
47
