7
9.
Make sure that all parts are properly tightened before you use the exercise cycle.
Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
8. Identify the Left Pedal (10), which is marked with an
“L”. Using an adjustable spanner,
firmly tighten
the
Left Pedal
counterclockwise
into the left arm of the
Crank (12). Tighten the Right Pedal (not shown)
clock-
wise
into the right arm of the Crank.
Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten
the Pedals. For best performance, the Pedals must
be kept tightened.
8
10
12
7
7. Position the Handlebar (3) inside the hinged bracket on
the Upright (2). Attach the Handlebar with the Handlebar
Cover (18), a Handlebar Spacer (21), and the
Adjustment Handle (17).
Connect the console pulse wires to the Pulse Wires (57)
as shown. Insert the excess wiring into the Handlebar
(3).
18
21
2
17
3
6. Have another person hold the Console (5) near the
Upright (2). Connect the console wire to the Upper
Wire Harness (30).
Insert the excess console wire and Upper Wire
Harness (30) downward into the Upright (2). Slide the
Console (5) onto the Upright.
Be careful to avoid
pinching the wires.
5
6
Be careful to
avoid pinching
the wires.
2
30
Console
Wire
57
Console
Pulse Wires
