Page 77
WESMAR
INSTALLATION AND OPERATION
Terminal 39 raises the soundome when powered.
15.2.4 Wiring
the Limit Switches, except M18LS
Both the top and bottom limit switches are prewired
at the factory.
Terminal lugs 25 and 27 are prewired to the top
limit switch.
Terminal lugs 25 and 26 are prewired to the bottom
limit switch.
Connect terminal lugs to the same numbered ter-
minals on the Hoist Preamp Board.
15.3 Model 18LS Limit Switch Wiring
The M18 Long Stroke Hoist has two junction boxes.
One junction box has the Hoist Control Board and
Transmitter Receiver Board. The second junction box
has the terminal connections for the hoist travel selec-
tion switch and hoist limit switches.
15.3.1 Hoist travel selection switch wiring,
M18LS only
The hoist travel selection switch is prewired at
the factory.
Locate the selection switch close to the console. Run
the selection switch cable alongside the intercon-
nect cable. Connect the terminal lugs to the same
numbered terminals in the J-Box.
15.3.2 Wiring the Limit Switches
Both the top and the three bottom limit switches
are prewired at the factory.
Terminal 25 and 27 are prewired to the top limit
switch and connected to the same numbered termi-
nals in the J-Box with the terminal strip.
For 115 VAC
For 220 VAC
Summary of Contents for HD800/110-10
