Operating instructions
English
BA-MicroCube-1213-0
17
8. Trouble shooting
Fault
Cause
Trouble shooting measures
Storage container is overfilled
with ice cubes
Light barrier responsible for fill
point control of storage bin doesn’t
work
Adjust or replace light barrier
Water bath is overflowed with
water
Water overflow pipe is blocked
Clean water overflow pipe
Ice capacity of the ice cube
maker too low
1. Condenser is soiled
2. Insufficient ventilation
3. Room / ambient temperature is
too high
1. Clean condenser
2. Check specified lateral distances
and ensure optimum air circulation
3. Reduce room/ambient temperature,
if necessary relocate the machine.
Replace air-cooled machine with
water-cooled machine if necessary
Water bath his not filled with
water
1. Water tap closed
2. Water inlet valve is blocked or
dirty
1. Ensure water supply
2. Clean primary screen
Storage container contains water
Drain tube of the storage container
is kinked, clogged
or has no
decline
Ensure free water drainage
Other troubleshooting should only be carried out by a specialist or by service staff from an authorised
WESSAMAT specialist dealer.
9. Disposal
9.1 Disposal instructions
If the machine would be put out of service, please follow the instructions below for disposal:
The refrigerant circuit of the ice cube maker contains HFC and lubricants that are harmful to water!
The machine must therefore be disposed of properly according to the relevant environmental protection
regulations. Should you have no options for proper disposal, please contact your specialist dealer or
WESSAMAT directly.
The orderly disposal includes:
•
Refrigerant R404a has to be extracted by a specialist and brought to a corresponding collection point
•
Waste oil must be let off and be disposed orderly.
•
Stainless casing parts must be disposed as stainless scrap steel.
•
Bring aluminium parts and aluminium cast parts to aluminium disposal points.
•
Non-ferrous parts (copper lines, brass parts) must be disposed as non-ferrous metal.
