•
Do not vacuum up heavy, hard or sharp-edged objects. You could block
and damage the electric brush.
•
Don’t operate the electric brush over exposed cables.
•
The electrical connector must be checked regularly for damage. If there
is any damage, the electrical connection piece must be replaced
immediately by a qualified small appliance repair professional.
Assembly and Connection to the Vacuum
Only operate this electric brush with the corresponding
battery wand. The integrated electrical connection
system will automatically couple when attached to the
PowerWand.
PowerWand
On/Off Switch
There are automatic locking mechanisms on the top
and bottom of this PowerWand. Press the release
mechanism to disconnect the handle from the wand or
the wand from the powerhead. The switch to turn the
electric brush on / off is located at the top of the battery
wand.
Please Note:
There is a delay when turning the brush on and off.
The operator must
PRESS AND HOLD
the button to
turn the brush on and off.
-4-
Charging
Shipping a fully charged Lithium-Ion Battery is
prohibited. A new battery just ‘out of the box’ will only
have a partial charge. To ensure a full battery charge,
completely charge the battery before using.
It is always best to disconnect the charger from the
battery after full charge has been achieved.
Recharge only by the original charger model 19.1 156-
300 and 19.1 155-300.
Operation
Depress on the on/off button quickly to activate the
status display for 10 seconds.
Press and Hold
the on/off button (> 2 seconds) to
activate the display and power-up the powerbrush.
During operation the display shows the actual status of
battery.
Press and Hold
the on/off button (> 0.5 seconds) to
power off the powerbrush.
-5-