The push/pull resistance can also be lowered if your
vacuum is equipt with an adjustable vacuum/suction
control. Reducing RPMs of the vacuum will reduce the
push/pull resistance.
Cleaning efficiency is only slightly diminished as
adjustments are made.
It is suggested that the brush roller is switched off when
cleaning delectate floor coverings, such as sensitive
wool carpets, some deep-pile carpets, carpet fringes,
animal skins or similar.
Overload protection
This powerhead is equipt with automatic overload
protection. This ‘circuit breaker’ will be activated when
the motor is overloaded or the brush roller is blocked
and cannot turn. This commonly occurs when a bulky
object is accidentally vacuumed. Typical objects that
stop the rotating brush are socks, strings, fringes of area
rugs, long human or pet hair.
If this happens:
Switch off the electric brush and disconnect it from the
power source. (disconnect the powerhead from the
battery wand).
-8-
•
Eliminate the cause of the error. If necessary, clean
the brush roller as described under Care.
•
After a short wait (> 15 seconds) the device can be
switched on again.
Maintenance and Care
Attention! Remove the powerbrush from the
power source before conducting any work on the
device
(disconnect the powerhead from the battery
wand).
The battery pack is maintenance free.
Do not allow cleaners, disinfectants or liquids to enter
any openings in the device. Failure to do so could cause
damage to the device and the operator.
If hair or threads are wrapped around the brush roller:
•
Cut threads and hair with scissors (picture 4).
•
Switch on the vacuum cleaner and electric brush. The
cut hair and threads will be sucked into cleaner.
Additional Maintenance work, in particular replacement
of components and repairs, may only be performed by
a trained and experienced small appliance repair
professional.
-9-
