2
OPERATING INSTRUCTIONS
READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL
BEFORE OPERATING LIGHT.
Step 1: To activate light, plug the DC adapter into
a DC receptacle. Move switch to ON.
WARNING:
Never place light face down when light is on or
is still hot from recent use. Doing so could burn/ignite
surfaces such as seats, carpeting, etc. and cause
major property damage. Always turn light off
and unplug from power source when not in use.
Step 2: To deactivate, move switch to OFF and unplug from
power source.
To Replace Bulb
Lens
Rear
Housing
Front
Housing
Reflector
IMPORTANT: Do not touch the glass part of bulb with fingers as natural
oils affect the life and performance of bulb. Handle bulb by
metal end only.
Step 1: Disconnect light from power source.
Step 2: Remove the two screws from top and bottom of front housing
(see Figure 1).
Step 3: Lay the light face (lens) down on a flat surface.
Step 4: Holding the front housing secure, slowly lift the rear
housing off.
Step 5: Pull reflector away from rear housing being careful not to pull
wire connections inside. Do not touch the inside of reflector.
NOTE:
The glass lens is not attached to front housing. Use care when
disassembling to avoid breaking lens.
FIGURE 1
Only use a halogen bulb that is designed for the light as a
replacement. Use of any other bulb may result in poor
performance and may damage your light.
