Page
10
of
14
To make things easier, attach the servo
and ESC control wires to the receiver
before attaching the fuselage sides.
Standing behind the plane looking at the
bottom of the wing, plug the left aileron
and left ESC into the aileron and throttle
receiver ports. Plug the right ESC into the
rudder port, and the right aileron into the
AUX 1 port.
To install the rear landing gear, first glue
the plywood base plate to the inside of
each motor nacelle with FT, align the plate
with the spar and the holes in the nacelle.
(note that the large hole in the base plate
is toward the rear of the plane).
Attach the wheels to the landing gear
using the plywood wheel collars and CA
glue. Do not get glue on the wheel, it
should spin freely.
