13
Westendorf Manufacturing Co., Inc.
WESTENDORFMFG RR315270
MAX Loaders
SECTION 3: MOUNTING / DISMOUNTING
1. With loader bucket rolled back,
lower the loader to the
ground or solid object.
PUSH
and HOLD
Button
WHILE HOLDING BUTTON, apply
down-pressure with lift cylinders, for 3-5
seconds to retract lower coupler pins.
FIRST Release Button
THEN Release down-pressure
2. Look to see that
lower pins are
retracted
and
unlocked.
3. Raise loader off the ground, slightly extend bucket
cylinders to swing the attachment
away from the couplers. Lower
arms and back away
from
attachment.
Remote Control Coupler Automatic Quick Change System
1. With lower pins
retracted, drive into
attachment center-
ing top coupler pins
in the self-aligning
“V-grooves” of the
adapters on the
attachment.
TIP
Ensure “V-grooves” are clean
for smooth pin travel during mounting.
Dismounting
Mounting
CAUTION!
Avoid injury from pins. Do not use hands
to remove obstructions while pins are under pressure.
2. Raise loader 3 to 5 feet off the ground.
Roll back the attachment until it is seated
fully against adapter.
3. PUSH and HOLD button 3-5 seconds
until lower pins lock into position.
If lower pins do not lock, continue to raise loader (watch
attachment while raising) to increase hydraulic pressure
to pins. HOLD BUTTON WHILE raising the loader.
4. Look to see that
lower coupler pins
are extended and
locked.
The Remote Control Coupler is a patented, automatic quick change
system that allows you to mount or dismount attachments from the
comfort of the tractor’s seat with the push of a button.
C-2
C-3
C-34
C-37
C-24
C-47
Female Snap-Attach™
Adapter Options
Adapters
Top Coupler
Pins
Keep the pin contact surfaces
clean and free of obstructions for
safe and proper operation.
Female Snap-Attach™ adapters are
available if you have other attachments
that you use often or if you need to share
attachments between multiple loaders.
Adapters are available to share between
20 & 40 Series and 40 & 70 Series loaders.
Shown
with Optional
Syncronizer Bar
